Slide the cables barrels into the valve catches and twist the throttle tube slightly to check that the valves open and close properly.
Throttle body cable install.
The cable must be adjusted so it is pulled fully out at wide open throttle.
Locate the throttle cable.
The gm tuned port injection tpi kit includes two throttle body fittings.
Loosen and remove the two 10mm bolts securing the bracket to the intake manifold then remove the cruise control and throttle cable from the bracket.
Loosen and remove the two screws securing the throttle cable and cruise control cable to the bracket.
1 2 and 3 for the component names.
To make sure disconnect the cable hold the throttle wide open with your left hand pull the cable fully out.
This is usually done by either.
Install the opposite ends of the throttle cables to the carburetor or throttle body tightening the threaded ends of the cable guides into the cable bracket completely.
The other end is on the driver s side floor attached to the accelerator pedal.
In this video i show how to remove your old stock throttle and idle cables and install some beautiful braided lines from magnum shielding.
Removing throttle cable from saturn s series throttle body.
I also show how t.
Throttle cables all lokar throttle cables are available in either stainless steel braided housing black stainless steel braided housing or black housing.
They are designed with a specially extruded liner for extended life of the cable not to be confused with ordinary braided brake hose.
The final step is to adjust the throttle valve cable.
8mm socket throttle cable assembly 10mm socket negative battery cable 13mm socket tb hold down bolts 25 torx driver tb sensors 3 16 allen wrench new tb hold down bolts 1 remove the throttle body hat.
Part 2 of 3.
This throttle cable is designed to be cut to fit for your particular application.
This video is not meant to be a definitive how to always consult a professional repai.
Disconnect the throttle cable at the throttle body.
The brass throttle body fitting with.
One end of the throttle cable is located in the engine compartment attached to the throttle body.
In fact most can be installed in less than 30 minutes with basic hand tools.
Yes from our first mustang 5 0l throttle body in 1988 to our latest auto truck units each bbk power plus series throttle body is designed as a simple do it yourself bolt on.
Can i install my own bbk throttle body.
Dislodge the throttle cable from the ball stud on the throttle body.
The aluminum throttle body fitting with two set screws fits early tpi systems up through 1988 fig.
