Throttle Control Cable Adjustment

Ensure that the throttle arm at the motor travels to the throttle stops.

Throttle control cable adjustment.

If adjusting your throttle cable doesn t eliminate problems with engine speed control have the issue looked into by your boat or motor dealer. Throttle freeplay is a terribly overlooked adjustment that can change both the reaction and comfort of your motorcycle. This video shows you how to install throttle and shift cables on a 1996 mercury 40hp outboard. The throttle valve cable is used to control the line pressure downshifting and the feel of the shifting.

Push the throttle to the full forward position. Push the throttle lever towards the slow position. And again push it towards the fast position to check the engine controls. If your boat and motor are still under warranty don t attempt to adjust the throttle cable.

Video showing the common methods of installing throttle and choke cables on both the auto choke and manual choke engines how to adjust them and how to chang. If it is turned on and off as per your command then the adjustment is ok. Move the cable to a lower hole on the control if the lever travel is insufficient to reach full throttle. Remove the cable by opening the unit and unscrewing the lock screw on the handle.

Many cars with automatic transmissions use a mechanical cable that runs from the transmission to the throttle linkage. Adjust the forward cable barrel while the throttle cable is in the full forward position. The manual says to spin trunion up to four 4 additional turns in one direction but i do not have that info at hand. Step 1 remove the cable housings using a pair of pliers.

Take the boat to the dealer as soon as possible. This throttle valve cable is responsible for controlling the throttle lever providing movement to the car. The housings will swivel off the base and slide down the cable. You may like my other videos.

Tighten the jam nut on the throttle cable with the wrenches. Install short cable back into shift bracket. Knowing how to adjust your throttle c. Adjust the cable so it fits snugly between the studs which are pre mounted and hold the shift cable in position.

With control shifter still in full forward full throttle position adjust brass trunion on control cable to fit onto easily onto shift bracket. Adjusting and replacing the throttle cable can be done at any level of mechanic skill. I do and do not do this so it is up to you. If there is slack in the cable then you need to make another adjustment.

If the cable is too tight then the lever is unseated off the roller.