Line up the fold with one of the horizontal lines on the cutting mat or if your mat is unlined use a square rotary ruler.
Using the mat cutter.
The logan mat cutter i use runs about 50 for the guide and cutting handle.
Step 1 take your fabric piece and lay it on your cutting mat so the raw edge is on the right side.
Before you begin cut your mat board to the size of your frame.
Use an x acto knife and a metal ruler to cut through the mat board.
Measure the reveal area you want around your art.
Mat board comes in sizes much larger than you ll need so use your dexter mat cutter to cut out an 8 by 10 mat.
The lines in the cutting.
Logan s 4000 deluxe is the only handheld mat cutter that we have included in this list as it is the company s most advanced handheld mat cutter.
The square ruler s left edge should be near but inside the left edge of the fabric roughly where you will make your square cut.
Simply measure off 8 inches one way and 10 inches the other.
Cut the mat board to the size you need.
Step 2 the first cut will be to the right edge to square up the fabric.
It consists of a marker bar system that allows faster marking.
Typically i leave a 1 4 on all sides.
You can also use hard mats these do not self heal but most do not cut easily so the effect maybe the same.
In this case have your ruler on the mat side and cut toward the center.
Don t attempt to tug or pull the center away.
For circle or oval cutting use the nt 45 degree bevel mat circle cutter that cuts perfect circles ranging 7 7 8 24 3 16 in diameter and ovals ranging 6 11.
Keep cutting light strokes with the ruler until the center comes away and drops out.
Place the fabric on the cutting mat fold near the bottom edge side to be squared on the left.
A rotary cutter can cut fabric pieces with sharp edges and straight edges very easily when used in conjunction with the mat.
Always cut away from the important part.
A video demonstration of the logan 4000 deluxe pull style bevel cutter.
Use three light cuts to get through the board.
Line up the crisp folded edge to the bottom of your mat.
To make architectural models use the nt 45 degree bevel mat board cutter for straight lines and cut mat boards into 45 degree bevel edges to join the edges together for a neat corner.
Line up your ruler with the folded edge using the lines to make sure it s straight.
A self healing mat is the best as the rotary cutter blades would not damage the mat.
